- Raspberry Pi & Accessories
- Raspberry Pi Kits
- Raspberry Pi Board
- Raspberry Pi Case
- Raspberry Pi Came
- Raspberry Pi Accessories
Shop
Showing 81–100 of 2348 results
- Through Hole Capacitor
1000uF 25V Electrolytic Capacitor in Pakistan
This Through Hole Mount (DIP) Multilayer Ceramic Capacitor is made of ceramic dielectric in which a number of interleaved metal electrodes are contained. It is very low cost and used mostly for reducing the noise or filtering on data lines, power lines, etc.
SKU: D1213 - JK BMS
100A Smart BMS 8S 20S 24V to 72V JK BMS Active Balance BMS In Pakistan
This JK bms is especially used for 8S to 20S Smart fixed configuration .For most important that it can also be used for any other lithium technologies like LiFePo4, Li-ion, LiPo and Lithium Metal by changing the internal parameters after connecting to Bluetooth App.
SKU: D2958 - DALY BMS Li-ion And Lifepo4
100Balance BMS 60A 8S-24S Smart Active Balance BMS In Pakistan
This is a full-featured DALY 100 Balance 8S-24S 60A Smart active balanced BMS with CAN/RS485 communication ports. 7~24 strings 40A intelligent multi-strings with 1A balancing current.Build-in Bluetooth module, Supports simultaneous multi-channel communication: WIFI / UART / GPS(4G)/HEATING / BUZZER/ TEMPERATURE, etc.
SKU: D2942 - Through Hole Resistor
100K Ohm 1/4 Watt 5% Carbon Film Resistor Through Hole In Pakistan (12 Pcs)
Quick View
Through Hole Resistor100K Ohm 1/4 Watt 5% Carbon Film Resistor Through Hole In Pakistan (12 Pcs)
This is an 100K Ohm 0.25W 5% Carbon Film Resistor Axial Through-Hole pack of 12 pieces. These carbon film axial through-hole resistors have an operating range of -55C To +155C with a rated power of 0.25 Watts or 1/4 Watts. The maximum working voltage is 300 Volts and the maximum overload voltage is 600 Volts for these resistors.
SKU: D1027,SB193 - UNI-T Digital Oscilloscope
100MHz Oscilloscope Scope Clip Probes P6000 in Pakistan
(Advance Payment Only)
(Delivery Via Cargo Service)
100MHz Oscilloscope Scope Clip Probes P6000 is used to connect the scope to your electrical circuit. 100MHz Oscilloscope Scope Clip Probes P600, the BNC connector is attached by pressing it into the connector on the scope and turning. The alligator clip is your ground connection and must always be connected to your circuit’s ground. The witch hat goes on the end of the probe and allows you to easily connect to things by simply pressing it down. Do not remove the witch hat. The vertical scale or voltage is controlled with these two knobs. The position knob will adjust where the signal is in the vertical direction. The scale knob adjusts how many volts each vertical block represents. The buttons on the left are for selecting which channel you are editing.
SKU: D817
