Electronic Devices And Components

74LS109 IC in Pakistan

The 74LS138 is a 3:8 Decoder IC that is commonly used in decoding or de-multiplexing circuits for memory decoding or data routing purposes. It is designed for high-speed operations and has three enable pins to make it easier to cascade with other ICs. The device decodes 1-of-8 lines, set by x3 binary select inputs & three enable inputs. The LS138 can be used as an 8- output demultiplexer by using one active LOW Enable input as data input & the other Enable inputs as strobes. The IC has an operating voltage from 1.0V to 5.5V with a low power consumption of 32mW. The propagation delay is around 21nS.

The 74LS160 IC package, consisting of 16 pins, contains a single 4 bit synchronous counter circuit which can be wired for decade counting mod, without external logic chips. By wiring more than one 74LS160 together (cascading), it is possible to make higher count lengths (powers of ten). For example, two 74LS160s cascaded together would yield a counter capable of decimally counting the range 00 – 99.

The 74LS189 is a high-speed 64-bit RAM organized as a 16-word by the 4-bit array. Address inputs are buffered to minimize loading and are fully decoded on-chip. The outputs are 3-state and are in the high impedance state whenever the Chip Select (CS) input is HIGH. The outputs are active only in the read mode and the output data is the complement of the stored data.

These full adders perform the addition of two 4-bit binary
numbers. The sum (R) outputs are provided for each bit and
the resultant carry (C4) is obtained from the fourth bit.
These adders feature a full internal look ahead across all four
bits. This provides the system designer with a partial lookahead
performance at the economy and reduced package
count of a ripple-carry implementation.

This device contains four independent gates each of which performs the logic OR function. The 74LS32 is a 14-Pin Quad 2-Input OR Gate IC. The 74LS32 provides four independent 2-input OR gates with standard push-pull outputs. Featured by Sharvi Electronics The device is designed for operation with a power supply range of 2.0V to 6.0V. Inputs include clamp diodes. This enables the use of current-limiting resistors to interface inputs to voltages in excess of VCC.