10S 36V 30A Li-ion Protection Board Li-ion Cell 18650 Battery Protection BMS in Pakistan

Has a balance function that would ensure each cell is fully charged at the same time.Overcharge protection, over-discharge protection, and short circuit protection.
With temperature control protection function. Fine workmanship and good performance. Safe and reliable. Easy to use. Long service life. Suitable for 10-series cell Li-ion batteries, can be used for 3.7V ternary batteries, manganese acid batteries, and cobalt acid batteries. Suitable for electric cars, electric assistant cars, skateboard cars, inverters, etc.

Specifications:

• Applicable Voltage: 36V
• Applicable: less than 1000w
• Max. Working Current: 30A
• Continuous Maximum Current: 20A
• Over-discharge Protection Voltage: 2.6v
• Overcharge Protection Voltage: 4.25v
• Charg Current: max. 10A
• Balance Voltage: 4.2v
• High-Temperature Discharge: 75 ℃
• Low-Temperature Charge: – 7 ℃
• colour: Silver
• Material: Metal

BMS Protection Board Wiring Steps:

1. 1. First connect the batteries in series
2. 2. Ensure that the voltage of each string is the same (the difference between the highest voltage and the lowest voltage is preferably within 0.1V), and that the voltage range is between 3.2-4.0V.
3. 3. Firstly connect the distributed cable, connect according to the diagram, and insert the cable port into the board port after checking it is correct (first connect the battery, then insert the board, the step cannot be reversed).
4. 4. Check whether the total positive voltage of the C-port and P-port to the battery is equal to the total voltage of the battery. If they are equal, the board is working normally.
5. 5. Solder the battery negative B- to the port marked B- on the board.
6. 6. Both the battery output negative electrode and the charging negative electrode of the same port board are connected to the port marked C- on the board (the P- port is just floating).
7. 7. Separate port (different port) board, the battery output negative pole is welded P-, and the charging negative pole is welded into the port marked C- on the board.

Package Contents:

• 1 x Protection Board
• 1 x Cable