74LS08 74AHS08 SN74LS08N LS08N 7408 QUAD 2-input AND Gate in Pakistan

74HC157 is a high-speed multiplexer integrated circuit consisting of four 2-input digital multiplexers inside the chip. It is pin-compatible with Low-power Schottky TTL. It has two control inputs namely enable and select input. Additionally, it has two groups of registers. The selected input determines the register from which the data comes. Its operation is specified over a temperature range of -55 °C to 125 °C.

The 74HC165 is a high-speed Si-gate CMOS device and is pin-compatible with low-power Schottky TTL (LSTTL). They are specified in compliance with JEDEC standard no. 7A. The 74HC165 are 8-bit parallel-load or serial-in shift registers with complementary serial outputs (Q7 and Q7) available from the last stage. When the parallel load (PL) input is LOW, parallel data from the D0 to D7 inputs are loaded into the register asynchronously. When PL is HIGH, data enters the register serially at the Ds input and shifts one place to the right (Q0 –> Q1 –> Q2, etc.) with each positive-going clock transition. This feature allows parallel-to-serial converter expansion by tying the Q7 output to the DS input of the succeeding stage. The clock input is a gated-OR structure that allows one input to be used as an active LOW clock enable (CE) input. The pin assignment for the CP and CE inputs is arbitrary and can be reversed for layout convenience. The LOW-to-HIGH transition of input CE should only take place while CP is HIGH for predictable operation. Either the CP or the CE should be HIGH before the LOW-to-HIGH transition of PL to prevent shifting the data when PL is activated.

The 74LS138 is a 3:8 Decoder IC that is commonly used in decoding or de-multiplexing circuits for memory decoding or data routing purposes. It is designed for high-speed operations and has three enable pins to make it easier to cascade with other ICs. The device decodes 1-of-8 lines, set by x3 binary select inputs & three enable inputs. The LS138 can be used as an 8- output demultiplexer by using one active LOW Enable input as data input & the other Enable inputs as strobes. The IC has an operating voltage from 1.0V to 5.5V with a low power consumption of 32mW. The propagation delay is around 21nS.