- Raspberry Pi & Accessories
- Raspberry Pi Kits
- Raspberry Pi Board
- Raspberry Pi Case
- Raspberry Pi Came
- Raspberry Pi Accessories
7405 Hex Inverter, Open collector in Pakistan
7405 Hex Inverter, Open collector
Based on 0 reviews
Be the first to review “7405 Hex Inverter, Open collector in Pakistan” Cancel reply
Related products
- 74LS And 74HC Series IC
74LS148 3-Bit Priority Encoder IC (74148 IC) DIP-16 in Pakistan
0 out of 5(0)74LS Series ICs are High-Speed Logic gates, ideally a little faster than the 74HC series but more power consumption is required. They are implemented with a Low-Power Schottky diode technology to achieve high switching speed. 74LS148 is one of the 74LS series IC. 74LS148 ICs contain an 8 to 3-Bit priority encoder that converts 8 Data Lines to 3-Line binary. Cascading circuitry (enable input EI and enable output EO) has been provided to allow octal expansion without the need for external circuitry.
SKU: D2024 - 74LS And 74HC Series IC
7404 74LS04 74HC04 Hex Inverter IC in Pakistan
0 out of 5(0)The 7404 is a triple-buffered inverter. It has high noise immunity and the ability to drive 10 LS-TTL loads. The 74HC logic family is functionally as well as pin-out compatible with the standard 74LS logic family. All inputs are protected from damage due to static discharge by internal diode clamps to VCC and ground.
SKU: D2004 - 74LS And 74HC Series IC
74LS76 DUAL JK FLIP-FLOP IC in Pakistan
0 out of 5(0)74LS76 comes with dual JK flip-flops. JK flip flops are widely used in daily electronics devices by many methods but the basic operation of the JK flip flop is to store a bit. JK flip flop allows it to store a bit and then allows it to use for further functions. in digital electronics circuits. JK flip flop is one of the popular flip flops due to its clock input, pre-set, and clear functionalities. The JK flip-flop changes its state under the clock pulse signal. The clock signal can be either a positive edge or a negative edge. The clock pulse gives multiple advantages to the flip-flop. 74LS76 also has provided a feature to neglect or prevent invalid outputs.
SKU: D2025 - 74LS And 74HC Series IC
IC 74LS85 4 Bit Magnitude Comparator DIP 16 in Pakistan
0 out of 5(0)74HC85 4-Bit Comparator IC (7485 IC) DIP-16 Package. 74LS85 is the four-bit magnitude comparators that perform a comparison of straight binary and straight BCD (8-4-2-1) codes. Three fully decoded decisions about two 4-bit words (A, B) are made and are externally available at three outputs. These devices are fully expandable to any number of bits without external gates.
SKU: D2017 - 74LS And 74HC Series IC
74HC165 Parallel To Serial 8 Bit Shift Register IC in Pakistan
0 out of 5(0)The 74HC165 is a high-speed Si-gate CMOS device and is pin-compatible with low-power Schottky TTL (LSTTL). They are specified in compliance with JEDEC standard no. 7A. The 74HC165 are 8-bit parallel-load or serial-in shift registers with complementary serial outputs (Q7 and Q7) available from the last stage. When the parallel load (PL) input is LOW, parallel data from the D0 to D7 inputs are loaded into the register asynchronously. When PL is HIGH, data enters the register serially at the Ds input and shifts one place to the right (Q0 –> Q1 –> Q2, etc.) with each positive-going clock transition. This feature allows parallel-to-serial converter expansion by tying the Q7 output to the DS input of the succeeding stage. The clock input is a gated-OR structure that allows one input to be used as an active LOW clock enable (CE) input. The pin assignment for the CP and CE inputs is arbitrary and can be reversed for layout convenience. The LOW-to-HIGH transition of input CE should only take place while CP is HIGH for predictable operation. Either the CP or the CE should be HIGH before the LOW-to-HIGH transition of PL to prevent shifting the data when PL is activated.
SKU: D2016










There are no reviews yet.